Re: Emission setup on NZ market bikes

[pdmeikle57]

#5390

Thanks guys

I've done some more snooping and come to the following:

Bikes for NZ/Auss/Canada don't have a CAT or any CCP plug.

They run a seperate "CO potentiometer" which you plug into the existing wiring loom. This is used for setting the idle mixture. If you remove the CAT & CCP and don't add a CO pot then the bike will idle rich. You can buy the CO pot from BMW dealers.

So, the config to aim for is:

As mentioned, remove the CAT

Remove any CCP plug, then remove the Motronic fuse for 1 minute to reset the unit.

Install a CO pot and set it with the bike hooked up to an exhaust gas analyser.

Apparantly, when you remove the CCP the motrinic unit ignores the O2 sensor.

Now I just need to find someone that can weld stainless steel.

Cheers
Tracy